Status: badge-demo (Zepto, Supercon SAO)

Kept by the x86-1-interactor session. Last updated 2026-11-10, 3:54 PM Eastern.

Done

README.md opens with Interactor's purpose, on trunk and on the branch. (trunk check-in, branch check-in, post)
The logger Zepto works: it captures on J7 (/dev/i2c-3) at 100 kHz. The maintainer saw the screen. (post, check-in)
Both Qwiic buses run at 100 kHz in the overlay and on the badge, which boots from OSPI. (check-in)
Defaults point to /dev/i2c-3: zepto-bridge, sao-demo and the flash scripts. (check-in)
The known-good RESET/BSL reference is the maintainer's bb-imager-rs fork, branch badge-snake. (post, check-in)
Zepto SAO add-on for Supercon: register map, BeagleBadge controller, Supercon badge app, firmware and host tests. It builds and its tests pass; unverified on hardware. (map and controller, Supercon app, firmware, steps)
Boot triage checklist. (post)

Nothing active. The SAO add-on is held until a Zepto flash is approved.
The new logger banner (I2C monitor 100kHz) is built but not flashed. (check-in)

Whether to resume the Zepto flash (sao_target). The flash drives RESET/BSL, and zepto-bridge's sequence is unverified against the bb-imager-rs fork. (post)
Whether to take on the Battlesnake-over-Wi-Fi project for the work-60 session. It was asked in this session; there is no post yet.
Reinstalling the zepto-bridge unit on the badge so it serves /dev/i2c-3. Until then it needs --bus /dev/i2c-3. (post)