Cleave status

Updated when a milestone moves. Times are Detroit time. (unverified) marks something this session hasn't checked itself.

Done

BeagleY-AI boots BQ2 with cleave-init from cleave's own BSP build: TF-A, OP-TEE, U-Boot for R5 and A53, and the kernel, all built with LLVM in the BQ2 seed. Seen in the console log. Fixes along the way included aa583ff07f and 7c953f8299.
Wi-Fi on the board, with two fixes applied by hand: 9a0ea79b24 (modprobe one alias at a time) and c78d3e431d (the CC33xx firmware). wlan0 got 192.168.0.177 by DHCP (console log). Monday Nov 2.
Wi-Fi and hostname read from bb-imager-rs's cloud-init customization: 8a567c5da3.
An SD image with all of the above, built on aarch64-1 by run 8903f7759f: beagley-ai/sdcard.img.xz. Monday Nov 2, 8:21 PM.
The cause of HTTPS failing from the board found: BQ2's busybox wget and LibreSSL disagree (report). Filed as bootstrap-qcow2 ticket d78258f03b.
Kconfig dialects for Zephyr and QEMU (32f9484084, 8385bfd645), and binman's x86 ROM layout (c05822f40b), for Glint. (unverified) that Glint uses them.
cc33xx-nvs.bin not needed: wlan0 already has the chip's own MAC address, in TI's block, and the driver reads only a MAC address from that file (b873e3f965).

Boot test of the cloud-init image: waiting on the maintainer, below.
HTTPS from the board: BQ2's fix is on its branch seed-ocx-links (ee75b652a0), not merged, and no seed has been built from it yet (unverified: from bootstrap-qcow2's session). Next: point tools/build-beagley-ai-bsp.sh at the new seed and rebuild the image. Until then, wget --no-check-certificate.
OCX protocol v2: cleave's aarch64 build pattern rewritten for v2 on branch protocol-v2-pattern (90c85fcf6a). It waits on aarch64-1's daemon moving to v2.
Signed regulatory.db in the image build (b873e3f965). Built and boot-tested: not yet. The image rebuild waits on aarch64-1 moving to v2.
Idea, not planned: Mesa Teflon and Whisper on the BeagleY-AI, ticket 4b6942f7be.

Flash beagley-ai/sdcard.img.xz with bb-imager-rs (customization cloud-init, with a Wi-Fi network, and no wpa_supplicant.conf on BOOT), then boot it with tools/serial-relay.sh running (post). The console log's last write was Monday Nov 2 at 11:28 AM.
Once aarch64-1 is on v2: merge protocol-v2-pattern into trunk (post). create takes patterns only from admin or setup.